Helsinki Graphite Lustre Wall Tile – 60cm x 30cm

ProClean Tile & Grout Sealer

UltraTile Tile & Grout Sealer is a premium, non flammable impregnating sealant that offers excellent stain protection against oil and water spills with a low odour, UV stable, colourless and nonyellowing appearance.

Tile and Grout Sealer can be applied to damp stone and grout immediately after installation with this fast track formula. It penetrates to protect all types of natural stone surfaces, i.e. travertine, terracotta, limestone, marble, granite, sandstone and many other porous stone surfaces such as plain or exposed aggregate concrete, slate, concrete pavers etc.

DIRECTIONS FOR USE

1. Always perform a test in an inconspicuous area on-site to check suitability of product, prior to use - read these instructions fully before application. If you experience difficulties using this product, please contact our technical support team on the number above.
2. Use without thinning down. Surfaces should be clean, dry & free from oil, grease, dust, and any other debris. Do not apply in temperatures below 5°C or above 25°C and should not be subjected to extremes of temperature until completely dry.
3. Apply a generous, even coat of Tile and Grout Sealer to the surface and edges of the stone using a roller, sponge, lint free cloth or brush. Ensure even distribution by wiping over several times, remove any surface sealer that has not penetrated the tile or stone after 15-20 minutes.
4. Apply a second coat, allowing a minimum of 30-45 minutes drying between coats, repeat the process and remove any excess sealer from the applied area with a dry lint free cloth. It will take up to 24 hours before the product will offer full protection. Until this has happened, keep the surface free from water and oil spills, as stains may occur before fully cured.